Forum Replies Created
-
Posts
-
Ok but can you check it for version 2.3? That’s the one I have. Using NTC-CA the rebarDiameterRatio is even worse, 1.722.
Thank you for the answer, but I’m trying to upload the file but it says “upload failed! File not allowed”…
Thank you for the quick answer, but it takes forever anyway, not happy about this at all, especially when checking, fixing issues and re-checking elements takes place multiple times… that’s a shame since I think the software in general is really good.
Ok thank you, I didn’t know that the wall_ identifier is required. As for wood-armer moments, I used a post from 2019 about designing slabs with this method, since I didn’t find the topic on the user manual, so thanks for the clarification.
I still can’t perform checks on assigned rebars though, or use the static rebar design option, clicking the button “perform checks” in both cases doesn’t do anything.One more question. You used for Q-Cat.H psi2=0.3 which is not the psi2 for Cat. H, it is 0. Where is this value taken from?
Ok thank you, so hand calculation was right. Thank you also for explaining the choice of the combination multipliers for variable loads.
Yes the program is updated, so I’ll wait for you to release a patch.I’m not trying to duplicate directly the spring. What I meant is that when there’s already a spring property that you created before and you enter the assign property window, it shows you the property you already created, and from there you change the name and create the new one, but if you checked the NL box in the previously created spring property it stays checked even with the new one. The only way to avoid interference from the previously created NL spring when creating another for a different direction is just to set to 0 Kclosure for the direction you’re not applying any property. But if you could make NL DoFs removable in the future, that would be much appreciated! Thanks for the help and sorry about the analysis, I used to work with another software that showed the final step right away.
Not trying to hang the box, but thanks for the advice!:)Regarding the creation of a new spring property, I applied exactly the same steps you described above, but since a spring property with NL DoFs was already created, it is not possible to add a new one without NL properties. So I have to delete the first one and start over, creating the one without NL properties first and then the second with the NL for one or more chosen direction, but I still cannot create a third one with a NL property for a different direction because I cannot uncheck the choice from the previous one. Maybe it’s because, as you said, removing NL dofs is not supported and this affect the creation of a new property too?
For the second question, here it is the model. Thank you in advance.
