- This topic has 3 replies, 2 voices, and was last updated 3 weeks, 1 day ago by .
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Home › Forums › NextFEM Designer support forum › Type initializer for ‘nflib.nflib’ threw an exception
Tagged: error international setting
I downloaded and installed the program(NextFEM Designer v2.5),
but it won’t start due to an error.
The following error message appears:
“The type initaializer for ‘nflib.nflib’ threw an exception.”
Is there a solution?
Hello,
yes, in Control Panel, open International Settings. In Administration options mask and Non-Unicode program language, click Change system locale setting… and set the language to English.
Then restart the program.
Thank you for your prompt response.
As you advised, I resolved the issue by setting the “language for non-Unicode programs” to English.
in Control Panel, open International Settings. In Administration options mask and Non-Unicode program language, click Change system locale setting… and set the language to English.
This should not be required anymore since version 2.5.0.3.