Home › Forums › NextFEM Designer support forum › Modeling of a single rebar responsible for tension in a beam

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 13, 2025 at 8:38 am #6196
    Yong Hyeon Cho
    Participant

    I’d like to inquire about modeling tensile reinforcement in an RC beam. Using a single rebar, I want the tensile reinforcement to be positioned at the bottom in the center and at the top at both ends. Could you recommend how to model the rebar transitioning from the bottom to the top and vice versa in the “Assign beam rebar” panel?

    August 13, 2025 at 1:08 pm #6197
    NextFEM Admin
    Keymaster

    Hello,
    In Fast rebar positioning box, select Bottom and 1 bar, the press Add. Same for Top. If 1 bar is selected, then it will be positioned in the center.
    Remember also to select the rebar size on the left of rebar table before to use fast rebar positioning.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.